Minimum Recommended Hardware for
Ferguson Airport

Hardware Total Cost is $2074.42

These recommendations are based on what I believe would be a minimum requirement list of hardware to maintain aircraft only.  All at a minimal initial cost.  This would exclude any major repairs that may arise.  This list is not all-inclusive of all hardware that may be needed to maintain aircraft but I believe it will be a good foundation.  All quantities and pricing are from AircraftSpruce.com

These parts can be found for less from other suppliers but I would avoid SkyGeek.com.  I've had many unbelievable issues with them.  Example: It took an extra two and a half weeks to finish the Annual on Bob's Dakota because SkyGeek.com couldn't get a $15 part to me in a reasonable amount of time.  This was a part they had in stock but didn't ship it out until five business days after I placed the order.  I put "Avoid Them" by their link in my Bookmarks.

Click on the links below for each type of hardware.  You'll then see the quantities and costs of the hardware I recommend in tables on each page of available hardware of that type, copied from the Aircraft Spruce website.  Click on the links below the tables on each page of hardware to order the parts from Aircraft Spruce.

Example Table.  

In the example table above, I'm only recommending buying 10 each AN3 (10-32) Cadmium Drilled 
and 25 each AN3 (10-32) Cadmium UnDrilled bolts for a total cost of $8.55.

Bolts

Nuts

	AN310 CASTLE NUTS
	AN320 SHEAR NUTS
	AN364 LOW PROFILE ELASTIC STOP NUTS
	AN365 ELASTIC STOP NUTS
	MS21042 ALL-METAL STOP NUTS
	EXHAUST MANIFOLD NUTS
	TINNERMAN NUT PLATES
	ANCHOR NUTS
	MS27151 PAL NUTS
Nuts Total Cost $833.60

Screws

Washers

Cotter Pins

Rivets

Parts Storage

Parts Bin Organizer from Home Depot
These are what I use to store my parts.